Pages

Sunday, April 21, 2013

Monty, The Pump, The Plugs, The Points & The Mountain. (all in that order)

Had a great few hours with Grant up at Trafalgar working on Monty the 28 Chev. I was going to go into a long technical description of what we did, but Grant has covered it in great detail in the post from his blog below.

Lets just say that after we did the pump, had lunch, did a minor tune up, Monty is again running like clock work, and with a new technology water pump to boot.

At the end of Grant's posting I have included a few videos of our cruzin around the highways and hills of Gippsland.



Posting from http://montythe1928chevrolet.blogspot.com.au/

1928 Chevrolet Water Pump - Revamped & Modernised

Gidday,

After about a six months break from any form of "Sunday Restoration Days" in the resto shed working on the Chevy with my mate Ray and this being because I have just been driving the ole banger around Gippsland most weekends since it was registered, so today we decided to install a new water pump onto the little 4 cylinder engine.
Not that the old existing one was broken or falling to bits, it's just that with the amount of driving I plan on doing in the years ahead a few little "modern" adjustments here and there make a big different to the running of the engine so I wanted to use an original 1928 water pump that has been retro fitted with modern internals, thus doing away with the old fashioned "white grease" cup and the large brass nut that always needs checking a nipping up to stop the water drips and also the constant oiling of the water pump shaft itself each time you start the car and since I have installed the small overflow tank to the radiator, the whole cooling system for the car will now be completely sealed and running at about 3lbs of pressure which also means that a anti corrosive inhibitor can now be used.


 
The revamped pump with modern internal bearings is the top one





 
No more hot water overflowing from the radiator onto the roadway each time when you stop, which means no more topping up the radiator all the bloody time either before and during a trip.

I decided to strip the Chevy of the hood, fan belt, water pump and radiator which took me only 20 minutes on Saturday, I had it cleaned down,  ready and waiting for a 9am start today.





 
Like clockwork Ray arrived and was walking down the driveway right on 9am and by 10.30am we had it all back together and running so quietly and smoothly with no leaks and the little brass overflow tank which is neatly tucked away doing a great job of keeping the hot water sitting nice and level... Great job!

Here are a few photos of the install:

First the high pressure washer was put the good use to clean out the engine block

 


Next the matching surfaces of the water pump and engine were cleaned of old glue and gasket material and then buffed to a mirror finish.


New sealant and gaskets were then re-fitted and the water pump installed and bolted up tight.






 
Everything else that was removed yesterday now went back on, the radiator was filled with water and a good job was completed quickly - PERFECT!!

Without a word spoken, next the mandatory washing of the hands took place, the removing of our greasy overalls and the opening of the driveway gate was all completed in one swift motion and we were off down the street for a test drive and once again the testing destination was to the township of Yarragon for lunch where we scored a park outside the pub...




Thanks and Cheers Grant Fowler




 
 
 

 



No comments:

Post a Comment